모두의 코드
RDMSR (Intel x86/64 assembly instruction)

작성일 : 2020-09-01 이 글은 1690 번 읽혔습니다.

RDMSR

Read from Model Specific Register

참고 사항

아래 표를 해석하는 방법은 x86-64 명령어 레퍼런스 읽는 법 글을 참조하시기 바랍니다.

Opcode*

Instruction

Op/
En

64-Bit
Mode

Compat/
Leg Mode

Description

0F 32

RDMSR

NP

Valid

Valid

Read MSR specified by ECX into EDX:EAX.

* See IA-32 Architecture Compatibility section below

Instruction Operand Encoding

Op/En

Operand 1

Operand 2

Operand 3

Operand 4

NP

NA

NA

NA

NA

Description

Reads the contents of a 64-bit model specific register (MSR) specified in the ECX register into registers EDX:EAX. (On processors that support the Intel 64 architecture, the high-order 32 bits of RCX are ignored.) The EDX register is loaded with the high-order 32 bits of the MSR and the EAX register is loaded with the low-order 32 bits. (On processors that support the Intel 64 architecture, the high-order 32 bits of each of RAX and RDX are cleared.) If fewer than 64 bits are implemented in the MSR being read, the values returned to EDX:EAX in unimplemented bit locations are undefined.

This instruction must be executed at privilege level 0 or in real-address mode; otherwise, a general protection exception #GP(0) will be generated. Specifying a reserved or unimplemented MSR address in ECX will also cause a general protection exception.

The MSRs control functions for testability, execution tracing, performance-monitoring, and machine check errors. Chapter 35, "Model-Specific Registers (MSRs)," in the Intel(R) 64 and IA-32 Architectures Software Developer's Manual, Volume 3C, lists all the MSRs that can be read with this instruction and their addresses. Note that each processor family has its own set of MSRs.

The CPUID instruction should be used to determine whether MSRs are supported (CPUID.01H:EDX[5] = 1) before using this instruction.

IA-32 Architecture Compatibility

The MSRs and the ability to read them with the RDMSR instruction were introduced into the IA-32 Architecture with the Pentium processor. Execution of this instruction by an IA-32 processor earlier than the Pentium processor results in an invalid opcode exception #UD.

See "Changes to Instruction Behavior in VMX Non-Root Operation" in Chapter 25 of the Intel(R) 64 and IA-32 Archi-tectures Software Developer's Manual, Volume 3C, for more information about the behavior of this instruction in VMX non-root operation.

Operation

EDX:EAX <- MSR[ECX];

Flags Affected

None.

Protected Mode Exceptions

#GP(0)

  • If the current privilege level is not 0.

  • If the value in ECX specifies a reserved or unimplemented MSR address.

#UD

  • If the LOCK prefix is used.

Real-Address Mode Exceptions

#GP

  • If the value in ECX specifies a reserved or unimplemented MSR address.

#UD

  • If the LOCK prefix is used.

Virtual-8086 Mode Exceptions

#GP(0)

  • The RDMSR instruction is not recognized in virtual-8086 mode.

Compatibility Mode Exceptions

Same exceptions as in protected mode.

64-Bit Mode Exceptions

Same exceptions as in protected mode.

첫 댓글을 달아주세요!
프로필 사진 없음
강좌에 관련 없이 궁금한 내용은 여기를 사용해주세요

    댓글을 불러오는 중입니다..