OUT

Output to Port

참고 사항

Instruction Operand Encoding

Description

Copies the value from the second operand (source operand) to the I/O port specified with the destination operand (first operand). The source operand can be register AL, AX, or EAX, depending on the size of the port being accessed (8, 16, or 32 bits, respectively); the destination operand can be a byte-immediate or the DX register. Using a byte immediate allows I/O port addresses 0 to 255 to be accessed; using the DX register as a source operand allows I/O ports from 0 to 65,535 to be accessed.

The size of the I/O port being accessed is determined by the opcode for an 8-bit I/O port or by the operand-size attribute of the instruction for a 16- or 32-bit I/O port.

At the machine code level, I/O instructions are shorter when accessing 8-bit I/O ports. Here, the upper eight bits of the port address will be 0.

This instruction is only useful for accessing I/O ports located in the processor's I/O address space. See Chapter 18, "Input/Output," in the Intel(R) 64 and IA-32 Architectures Software Developer's Manual, Volume 1, for more infor-mation on accessing I/O ports in the I/O address space.

This instruction's operation is the same in non-64-bit modes and 64-bit mode.

IA-32 Architecture Compatibility

After executing an OUT instruction, the Pentium^(R) processor ensures that the EWBE# pin has been sampled active before it begins to execute the next instruction. (Note that the instruction can be prefetched if EWBE# is not active, but it will not be executed until the EWBE# pin is sampled active.) Only the Pentium processor family has the EWBE# pin.

Operation

IF ((PE = 1) and ((CPL > IOPL) or (VM = 1)))
    THEN (* Protected mode with CPL > IOPL or virtual-8086 mode *)
          IF (Any I/O Permission Bit for I/O port being accessed = 1)
                THEN (* I/O operation is not allowed *)
                      #GP(0);
                ELSE ( * I/O operation is allowed *) 
                      DEST <- SRC; (* Writes to selected I/O port *)
          FI;
    ELSE (Real Mode or Protected Mode with CPL <= IOPL *)
          DEST <- SRC; (* Writes to selected I/O port *)
FI;

Flags Affected

None

Protected Mode Exceptions

#GP(0)

• If the CPL is greater than (has less privilege) the I/O privilege level (IOPL) and any of the corresponding I/O permission bits in TSS for the I/O port being accessed is 1.

#UD

• If the LOCK prefix is used.

Real-Address Mode Exceptions

#UD

• If the LOCK prefix is used.

Virtual-8086 Mode Exceptions

#GP(0)

• If any of the I/O permission bits in the TSS for the I/O port being accessed is 1.

#PF(fault-code)

• If a page fault occurs.

#UD

• If the LOCK prefix is used.

Compatibility Mode Exceptions

Same as protected mode exceptions.

64-Bit Mode Exceptions

Same as protected mode exceptions.

첫 댓글을 달아주세요!

강좌에 관련 없이 궁금한 내용은 여기를 사용해주세요

다음으로 로그인

또는 직접 입력하세요 (댓글 수정시 비밀번호가 필요합니다)

댓글 달기

댓글을 불러오는 중입니다..